Granule:

Moocpa (marine bio-organ calcium), eco-friendly nano-plastic additive, converts the original structure into decomposable component. The additive ratio is between 20% and 60%, and general manufacture in injection, extrusion, membrane blowing, bottle blowing, inflation tubular film, and laminating.

Powder:

Moocpa (marine bio-organ calcium), eco-friendly nano-plastic additive, converts the original structure into decomposable elements. The additive ratio is between 20% and 60%, and manufacture in granule generation and foaming.

• 1.Mix
• 2.Feeding
• 3.Trial production
• 4.Thermoforming
• 5.Finished products

Injection:

1. The ratio of Moocpa additive is between 20% and 60%, the higher ratio the quicker degradation.
2. Temperature requirement ranges from 165℃to 240℃.
3. For common barrel size of injection machines, Moocpa additive should be more than 50kg to function normally.

P.S Heating temperature can be decreased 10℃ to 15℃ as injection machines works normally.

Extrusion：

1. The ratio of Moocpa additive is between 20% and 60%, the higher ratio the quicker degradation.
2. Temperature requirement ranges from 160℃ to 260℃.
3. For common barrel size of injection machines, Moocpa additive should be more than 200kg to function normally.

P.S Heating temperature can be decreased 10℃ to 15℃ as injection machines works normally.

Blow：

1. The ratio of Moocpa additive is between 20% and 60%, the higher ratio the quicker degradation.
2. Temperature requirement ranges from 165℃ to 220℃.
3. For common barrel size of injection machines, Moocpa additive should be more than 50kg to function normally.

P.S When the machine works normally, heating temperature can be adjusted in

• step 1: 195℃
• step 2: 190℃
• step 3: 185℃
• step 4: 175℃
• step 5: 170℃
• step 6: 165℃ to raise production quality.

Uneven color

Reason:

Density of Moocpa is heavier than plastics. It makes Moocpa material tend to sink in the bottom and not mixing well with plastics.

Solution: mixing well Moocpa material with plastics.

Reason for discovering little bubbles:

Moocpa material absorbs too much moisture from air. It makes Moocpa material become moist.

Solution: Drying Moocpa material by drying machine.

Impurity in product

Reason:

Barrel of machine remains impurity inside.

Solution:

Add Moocpa material into plastics and run three hours to discharge the impurity inside barrel.

1.Recycling: Recycling plastic garbage

2.Cleaning: The waste classification and recycling of plastic products clean

3.Smash: the cleaning finished plastic products, labeled as tiny fragments, easy processing

4.Tablets pumping: pumping tablets is granulation, discarded plastic debris heating products, manufacture granulated

5.Mix: Actuarial proportion of raw materials and general plastic mixing Moocpa

6.Manufacturing: re-manufacturing, manufacturing new plastic products